Unlike a necklace, it doesn’t matter if it’s too big or too small. The size of the ring is very important. It must be just right to wear it comfortably, so the size of the ring must be measured accurately.
The following Xiaobian to tell you how to measure the ring ring number?
A person’s hand is usually between size 4 and 26.
Women’s ring circle slogan for the majority of the 10-15, with 12 and 13 more common.
Male ring circle slogan for the majority of 17-22, 18, 19 and 20 are more common.
There are three ways to measure the size of the finger ring. One is the diameter method, the other is the circumference method, and the other is the special scale measurement.
Diameter method Diameter method is also divided into a direct measurement of usually worn rings.
Hold ONESELF TO WEAR COMFORTABLE RING, FLAT ON THE RULER THAT HAS ENGRAVED READING, SEE THE BIGGEST DIAMETER OF RING RING CIRCLE INSIDE THE CIRCLE IS HOW MANY CENTIMETERS, THEN REOCCUPY THE DIAMETER CONTROL THAT GETS ONESELF NUMBER.
The other is to measure the finger directly.
Compare the diameter of the finger with the ruler, and the scale on the edge of the finger is the diameter of the ring.
Or use vernier calipers to measure the diameter of your finger.
However, the diameter method has a disadvantage, that is, the error is relatively large.
The perimeter method The perimeter method can also be divided into three types, depending on the material used.
The easiest is the strip method.
First, wrap a small piece of paper around your finger, then cut out the paper and straighten it. Measure the length of the paper with a ruler, and then compare the ring size table to get the size.
It’s rope. It’s the same as paper.
After winding, measure the length and compare to get the size.
The above two methods have a disadvantage, that is, the measurement is the circumference of the root, without passing through the joint, there will be a certain error.
So the third way is to use the wire to measure.
Use the wire ring to make a round iron ring around your finger. Try to put on and take off the iron ring several times. After the tightness is moderate, fix the iron ring and mark the lower left.
Take off the iron ring and expand it into a straight line to measure the length, and then get the hand size according to the comparison table. It is better to use copper wire without elasticity.
