: How to clean and maintain the gap of the wood board?
Yacht board gap generally we will pay little attention to, and it is difficult to clean, today Xiaobian recommended several methods to maintain clean yacht board gap.
Clam shell seam is also known as corner seam.
A joint at the corner of a wooden boat shell.
If the adjacent side of the bottom plate and the ship plate planed into a bevel, like an open clam shell.
Usually pieced with spade nails and reinforced with curium.
Right-angle seam A seam in which the board material is cut adjacent to each other to fit a right-angle notch.
Half of the thickness of the adjacent sides of two sheets is shaved by cross planing.
Bite after the sheet material dry shrinkage also do not open seam, conducive to weatherproof.
It is generally used for floor roof and arch roof siding.
The suir raincoat sews the transverse and upper and lower pieces of wood, and the adjacent sides are cut into bevel seam.
When splicing, the inclined plane of the upper piece is outside, and the inclined plane of the next piece is draped, and each piece is lapped and spliced in turn.
The rain does not flow into the inside, like the coir rain of reason.
Generally used on the walls of the building.
The tongue-edge seam is cut into a convex and concave seam.
The scope of application is the same as that of right-angle sewing and coir raincoat sewing, but the strength is better.
Curve seam is also called free seam.
A curvilinear seam of wood adjacent to the edge.
When assembling the sheet material, such as the sheet material edge is any curve, in order to make full use of the sheet material, should not be cut straight, after dressing to make the edge reach a certain thickness, choose another piece of sheet material with the same curve edge, with set of ink or point ink sawing, the implementation of curve assembling.
