Believe that a lot of people have encountered the mechanical watch water stop, some people will say: I bought the watch is waterproof, why into a little bit of water it “hang”?
There may be a certain misunderstanding of the waterproof table, of course, if your mechanical table is really water, please do not worry.
The following table of the world Xiaobian will teach you some mechanical table water after coping with the method.
Mechanical watch water will lead to the service life of the watch, and even cause damage to the watch.
Most people in the life of the mechanical table water is not very understanding.
First of all, we need to understand that there are two kinds of mechanical watches, one is automatic chain, one is manual chain.
The difference between the automatic chain and the manual chain is that the automatic chain mechanical table has pendulum tuo, pendulum tuo can be provided by the movement of the human body to save energy to spring travel.
I believe that when you buy a table to consult waterproof related knowledge, general waterproof mechanical table is able to contact a small amount of water, such as early to wash a face with water splashing on the table.
Mechanical table waterproof depth is measured by atmospheric pressure standard (ATM or BAR), each atmospheric pressure value is equivalent to 10 meters of hydrostatic pressure, that is, 30 meters waterproof =3ATM.
(Physically speaking, the atmospheric pressure increases by 1 for every 10 meters of water depth, causing the case to burst loudly when the pressure inside and outside the case is unequal.
So the general mechanical table manufacturers are based on the pressure value to measure the waterproof function of the mechanical table, to pressure (ATM or BAR) waterproof depth.
If the mechanical table water, the following small methods can help reduce the damage of the watch: 1, mechanical table such as water soaked, available several layers of toilet paper or moisture absorbing floribundt table tightly wrapped, placed in the 40 watt light bulb near about 15 cm, baking for about 30 minutes, water vapor can be eliminated in the table.
Do not watch the table (table is we say the watch glass) close to the fire directly baking, so as not to make the table suffer from thermal deformation.
2, with granular silica gel and the watch has water into a closed container, a few hours later, take out the watch, the water is all gone.
This method is simple and economical, without any damage to the precision and life of the table.
The silica gel that has been absorbing water for many times can be dried for several hours at 120¡æ. The water absorption capacity is renewable and can be used repeatedly.
3, the mechanical watch inside, the bottom shell outward, reverse worn on the wrist, two hours after the water vapor can be eliminated.
If the water is serious, it is best to immediately send the table shop wipe oil, remove the moisture of the movement, in order to avoid parts rust.
If the above three methods do not work, small make up can only say, you still hurry to take your watch on the professional repair shop to go!
